Duracell POWERPACK300 Průvodce řešením problémů Strana 34

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 63
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 33
Jump-Starting a Vehicle’s Engine
21
If no alarm sounds, and the Green Jumpstart Connection
LED is illuminated, then proceed to the next step.
7. Switch
ON the jump-starting power switch.
Before starting the engine, make sure the Duracell®
Powerpack and the cables are clear of belts and fans.
8. Crank the engine for 4 seconds or until it starts,
whichever is first.
9. Switch
OFF the jump-starting power switch.
10. Remove the red positive (+) clamp and then the black
negative (–) clamp from the vehicle.
11. Store the jump-start clamps in the appropriate holder on
each side of the Duracell® Powerpack.
WARNING: Fire hazard
Do not crank the engine for more than 4 seconds. The jump-start
feature is designed for short term operation only. Operating the
jump-start feature for more than 4 seconds may cause damage to the
unit. Allow the Duracell® Powerpack to cool down for at least 3
minutes after each jump-start.
Important: Recharge the Duracell® Powerpack as soon as
possible after each use. See “Recharging the Duracell®
Powerpack Battery” on page 29.
Duracell_PP_300_PlusEP.book Page 21 Wednesday, June 13, 2007 4:02 PM
Zobrazit stránku 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 62 63

Komentáře k této Příručce

Žádné komentáře